The working principle of a hydraulic breaking hammer, as well a

  • The more general the industrial equipment is, just like the electric tools in your home, the better. Fixed booms, backhoes, skid steers, and even forklifts are all designed for a variety of tasks and have different primary functions. Everything is dependent on how you set up the machine.

    The excavator is one of the more adaptable pieces of equipment in this regard. In addition to the bucket that is used for scraping and digging, augers, compactors, rakes, rippers, and grabs can be added to the machine for specialized operations. If there is a job to be done, the excavator, like the Swiss Army knife, may be equipped with an accessory.

    Breaking hammer with hydraulic power

    Obstacles may prevent normal excavation from taking place at times. Hammers / breaking hammers are used to cut large stones or existing concrete structures in mining, quarries, excavation, and demolition. However, hammers provide a more controlled process when removing obstacles or breaking through thick rock layers.

    The hammer is propelled by a hydraulic piston, which applies pressure to the attachment's head in order to deliver a powerful and consistent thrust against the obstacle. In a nutshell, it's just a massive jackhammer. It is particularly well suited to small spaces and continuous production. The breaking hammer is less noisy and produces less vibration than blasting.

    Take all necessary safety precautions.

    Despite this, these powerful tools must be handled with the same care and caution as any other industrial machine. Injury and unnecessary cracks will be reduced during operation if experienced operators and observers work together. Understanding how the machine operates will also help you to get the most out of your hammer / hammer.

    The term "empty burning" refers to the fact that no object or material can withstand the force of the circuit breaker. As a result, the piston fires at the tool handle, but the energy released cannot be absorbed by the dead air. The impact is sent back to the tool, and it interacts with other impacts that have been transmitted down from the tool in the process.

    As a result of the large amount of force in the middle, the tool itself will be subjected to excessive pressure and wear. That is where experience comes into play. By anticipating the breakage of an obstacle, the operator can stop the circuit breaker before the target component is damaged or destroyed. This helps to reduce the number of empty fires while also protecting the tools.

    When does the hydraulic hammer need to be turned off?

    1. The hammer hose jerks violently back and forth.

    An abnormal surge in the hydraulic hammer indicates that the nitrogen energy chamber has been completely depleted. Close the tool and inspect the chamber before reopening it to determine the cause of the problem.

    2. The circuit breaker tool does not fall to the ground.

    It is possible for the tool to become stuck in the bushing, preventing the visible length of the part from being changed. If this occurs, you should immediately stop using the circuit breaker and remove the tool in order to inspect the bushingDetermine whether the marks on the tool and bushing need to be removed or replaced if there are obvious signs of sticking. After the issue has been resolved, the toolholder must be lubricated and thoroughly cleaned before the tool can be reinstalled.

    3. Leakage of hydraulic oil.

    If the hydraulic hammer begins to leak oil while in operation, it must be shut down to allow for proper maintenance. Defective side bars or excessive wear of the bushing can cause oil leakage.

    4. There is a gap between the suspension and the rear head of the engine.

    Of course, if there is a space between the suspension and the rear head area, you should not continue to operate the hammer. The presence of clearance usually indicates that the suspension needs to be repaired. Call a disassembly tool service or look through the user manual to see if you can fix it.