Welding Of Enameled Aluminum Wire And Copper Wire

  • Here is the enameled aluminum wire's welding instructions as follows. When welding, the soldering iron tip should be as close as possible to the body to be welded, and then the solder wire should be sent to the soldering iron tip to melt the soldering wire and complete the welding (this method can make the flux in the soldering wire) Fully contact with the board surface to achieve the best welding effect); for the welding of enameled aluminum wire and copper wire (or aluminum wire), after scraping the paint, the two wires are usually connected by twisting, and the size of the twisting It directly affects the welding effect. The larger the twist (that is, the radian), the greater the amount of tin filling, so that the welding between the two wires will be firmer; for the enameled wire that has just been welded, do not pull it by hand, but wait for it to be complete. Cool down, and then check its reliability; for the unused solder wire, use a lighter to burn the wire head into a ball to prevent the liquid flux in the wire from losing and affecting the next soldering.

    In fact, the welding problems of enameled wires are similar, and the same is true for Rectangular Enameled Aluminum Wires.