Stainless Steel Kitchen Sink Installation Rules

  • Stainless Steel Kitchen Sink installation precautions:
    1. Usually the stain on the surface of the sink is the welding debris and cement left behind, so the installation of the sink should be the final step of the decoration. Installing the sink is actually very simple. When you buy the sink, the merchant also has the package installed, or it is not difficult to install the professional master.

    1. When installing, do not store water in the water tank. The water in the water pipe should be drained. If there is water in the water tank during installation, it will cause rust and water leakage in the water tank.

    3, the installation of the sink should be reserved in advance, the size of the selected sink basin, the size should be consistent with the sink hole. Seal the interface when installing the faucet, pay attention to the sealing, and do not have any gaps to prevent water leakage. Install the faucet and inlet pipe before installing the sink. In addition, one end of the inlet pipe on the faucet is connected to the water inlet switch.

    1. The degree of sealing of the overflow hole and the filter blue is affecting the use of the sink in the future. Therefore, the degree of sealing of the overflow hole and the filter blue is very important. After the installation is completed, it is necessary to check the sealing of the overflow hole and the filter basket.
    2. After the installation, clean the sink and test the water. Fill the sink with water, carefully check the faucet, the water and the overflow hole to see if there is any water leakage. If water seepage is found, rework immediately. After the test water is normal and no water leakage is found, the side of the water tank is sealed with silica gel. The sealing is also to ensure that the water tank does not leak, so the gap between the water tank and the countertop should be even.