Stainless Steel Sink Manufacturers Shares 8 Steps Of Installati

  • I don't know if you have encountered such a situation after the renovation, the kitchen sink has not been used much, and there are a series of problems such as rust, mold, dark spots and water leakage, so that you don’t even have the mood to cook. . In fact, these problems are all caused by the neglect of details during the installation of the sink. The following AFA Stainless Steel Sink Manufacturers tells you how to install the sink

    In general, the steps for installing a sink are like this:

    Fixed position - installation of faucet and inlet pipe - sink placed on the countertop - overflow hole, filter seal - installation of pendants - drainage test - edge sealing - cleaning

    1, fixed position

    Before installing the sink, you must first determine the location and size of the installation, so that we can order according to the size, it is best to have a plan of the sink, so as not to be inaccurate data, resulting in rework. In addition, after the sink is installed firmly, do not shake it from side to side, it is easy to leave a gap and cause looseness. Moreover, the most important thing to note is the tightness of the joint gap.

    2, install the faucet and inlet pipe

    Before installing the sink, the faucet and inlet pipe should be secured first, and the inlet pipe at the other end should be connected to the water inlet switch.

    3, the sink is placed on the countertop

    After the sink is placed in the countertop, it is necessary to install matching pendants between the wall and the countertop, but pay attention to the sealing effect of the sink as much as possible during the installation process.

    4, overflow hole, filter

    The degree of sealing of the overflow and the filter determines the effect of the use of the sink in the future. The higher the sealing degree of the overflow hole and the filter, the less likely it is to be problematic in the later stage.

    5, install supporting pendant

    Installation of pendants is generally considered to be the last step in the installation of the sink. Generally, only when the sink is bought, the workers will cut the countertops according to the size of the sink and put them into the countertops. When installing, each gap should be filled to avoid water leakage problems in the future.

    6, drainage acceptance

    After the whole installation of the water tank is completed, the water tank needs to be filled with water to do the drainage test. If there is leakage, the problem should be solved immediately.

    7, edge banding

    After the drainage test ensures that there is no problem, the sink can be edged. When sealing with silicone, it is necessary to ensure that the gap between the sink and the countertop is even and there is no water seepage.

    8, clean up

    After the installation is completed, the sink must be cleaned to clean up the debris during installation. Do not use water directly into the water, it is easy to cause blockage.

    Tip: Finally, add some notes on the sink decoration.

    1 Sink installation should be left at the end to avoid damage during the renovation process.

    2 When installing the water tank, remember to drain the water in the water pipe, otherwise it will cause problems such as water leakage and rust.

    3 The installation of the faucet must be firm at the junction of the pillow. If there is a gap, it will lead to water leakage.

    4The sink is rusted and can be wiped with toothpaste. It will disappear naturally after normal use.

    5 It is best to put glass glue on the connection between the sink and the water leak.